Easily check your error code

LG · Washer

LG Washer OE Error Code: Not Draining — Causes & Fixes

Also shown as: E03, E21, Water Outlet Error

OE

OE is LG's water outlet error: the washer cannot drain. LG names a clogged drain pump filter and a kinked or frozen drain hose as the usual causes. A quick Spin-Only test tells you whether the pump itself is working.

Easy⏱ 15–60 minUpdated 2026-11-18

What OE means

The washer could not empty the tub. On top-loaders LG says the code appears after the washer has been unable to drain for 13 minutes. Newer LG front-load error lists group OE with E03 and E21 for the same drain problem.

Likely causes (most → least common)

  1. Clogged drain pump filter (front-loaders)Most common

    Lint, coins and small items collect in the filter behind the service cover at the bottom front.

  2. Kinked, pinched or frozen drain hoseVery common

    Vibration can pinch the hose behind the washer; in cold weather, water in the pump or hose can freeze.

  3. Excess sudsCommon

    LG explains that heavy suds create air pockets; the pump sucks air instead of water and reports a drain problem.

  4. Household drain cloggedOccasional

    A blocked standpipe or floor drain is a plumbing problem, not a washer fault.

  5. Failed drain pumpLess common

    If the pump does not hum during a Spin-Only test, LG says the washer needs a repair.

How to fix it, step by step

  1. Check the drain hose

    Pull the washer out and make sure the drain hose is not kinked, clogged or squeezed between washer and wall.

    Easy⏱ 5 min🔧 No tools
  2. Run the pump test

    Turn the washer on, select Spin Only (front-load: set spin speed to High and press Start/Pause). Listen for a hum and draining water during the first 15 seconds. A hum means the pump motor runs; silence means LG recommends service.

    Easy⏱ 5 min🔧 No tools
  3. Drain the residual water (front-loaders)

    Unplug the washer. Open the service cover at the bottom, put a shallow pan and towel underneath, unclip the small residual-water hose and remove its cap. If nothing flows, push the hose back in about 1 inch to remove a kink.

    Easy⏱ 10–20 min🔧 Shallow pan, Towels
  4. Clean the drain pump filter

    Twist the filter counter-clockwise to remove it, clean it with a soft brush and warm water (LG says not in the dishwasher), brush out the opening, then refit the cap on the small hose and screw the filter back in clockwise until it stops.

    Easy⏱ 10 min🔧 Soft brush or old toothbrush
  5. Thaw a frozen washer (cold weather)

    LG suggests pouring warm water (50–60 °C / 122–140 °F) into the drum, closing the door and waiting 1–2 hours for the pump to thaw before draining.

    Easy⏱ 1–2 h🔧 Bucket of warm water
  6. Test your house drain

    Take the drain hose out of the standpipe, put it in a bucket and run Spin Only. If the washer drains well into the bucket, the household drain is clogged.

    Easy⏱ 10 min🔧 Large bucket
  7. Run Tub Clean and cut the detergent

    If the filter was already clean, run a Tub Clean cycle and use less detergent to rule out suds.

    Easy⏱ 1–2 h🔧 No tools

When to call a professional

  • No hum from the pump during the Spin-Only test.
  • OE returns after a clean filter, a straight hose and a Tub Clean cycle.
  • The filter will not unscrew or the housing is cracked and leaking.

Parts that may be involved

Always match the part to your exact model number (rating label) before ordering.

Drain pump filter (model-specific)

If the filter or its seal is damaged and leaks.

Fit: Front-load models; match model number.

No price shown — prices are only listed when verified on a retailer page.

Drain pump assembly

For a pump that does not run — usually a technician job.

Fit: Model-specific.

No price shown — prices are only listed when verified on a retailer page.

Drain hose

Replace a cracked or permanently kinked hose.

Fit: Model-specific length and connector.

No price shown — prices are only listed when verified on a retailer page.

Related codes

Same problem on other brands

All LG washer error codes · Every code A–Z

FAQ

How do I test the drain pump on an LG washer?

Run Spin Only and listen during the first 15 seconds. LG says a hum (and draining water) means the pump motor works; if you hear nothing, request a repair.

Can too much detergent cause OE?

Yes. LG explains that excess suds form air pockets so the pump draws air and reports a drain issue. Run Tub Clean and reduce the dose.

Are OE, E03 and E21 the same?

LG's newer front-load error list treats them together as an inability to drain.

How do I force-drain an LG top-loader?

LG's top-load guide: start a cycle, pause it, and after about 8 minutes the washer times out, shows dR and tries to drain.

Sources

This guide paraphrases the manufacturer's own support documentation. We re-check sources regularly.